Ihr Warenkorb ist leer
Ihr Warenkorb ist leerXLC ST-T02 AluFor Vorbau 1 1/8 Zoll Gabel, 80 mm, Mattschwarz XLC ist eine junge und bereits international anerkannte Marke, die Fahrradteile und Zubehör entwirft.
opinions4u
Bewertet in den USA am29. Mai 2016
If you're looking for a bike stem to bring your handlebars up and back towards you, I would not recommend this one unless your handlebars are VERY far forward and downward. It only raises the bars slightly, and in fact is worse than the one I already have. According to the description, I thought this had a lot of swivel to it but no, it really doesn't move the bars much. You definitely will not get this straight up, it goes up to about 50 degrees angle, and I don't know how they figure it's adjustable to more than that. It's not. "edge" that prevents the stem from going up far. If you're leaning far forward and your hands are beneath your handlebars, this stem will raise them up to a slight angle, but it definitely will not pull your bars up and back for you to sit upright. I would not recommend this, there must be better ones out there.
Customer
Bewertet in den USA am31. März 2015
A fairly average headstem. Looks OK for your average city bike or hybrid, or as I'm using it, for converting an old mountain bike to touring, in combination with a set of butterfly bars.Not super light, but plently of quill length and the adjustment seems secure enough once tightened up.Just remember 80mm is a pretty short length.
Phil & Liz
Bewertet in den USA am27. März 2015
I have an old triathalon bike that's too small for me. As a result, I have the seatpost extended waaay out. The existing handlebar stem could only be extended a couple inches, so my handlebars were far too low - I couldn't even ride in my drops!Since this is an old bike, I needed a 22.2mm threaded quill stem. I first tried a quill stem extender, but it was useless - I couldn't tighten it enough to hold my handlebars in place.After that, I then went on a search for a different solution and found this. Although my bike generally looks like a road bike, luckily my handlebar diameter was 25.4mm (the mountain bike standard), not 26mm (the road bike standard).I picked this stem because it was the right diameter (22.2mm) and looked longer than my existing stem. Plus, I knew I could use the adjustment to rotate it higher if needed.Another plus with this stem is it's a 'pop-top', just like my old stem. That means the handlebar mount has bolts on both sides, not just one. The old style of stem has a bolt on just one side, so to change your stem you have to slide the handlebar all the way through on one side. For that to work you have to unwrap your bar and remove the brake levers, etc. Thus a pop-top stem makes a swap a lot easier.I was able to install this new stem in about 30 minutes, and it worked great! My old stem was about 6 inches long. This one is over 7" long (on the quill end) and the minimum line was further down than the one on my old stem. That gave me about 3 extra inches of height right off the bat. Plus, I rotated the adjustment up about 20 degrees, for another inch or more.Now my bars are high enough that I can grab the bottom of my drops comfortably. This makes a huge difference.I should note that I was lucky because my shifters are mounted on the stem, not on the handlebars. With handlebar shifters, you will probably have to install new cables and housings because the height increase will make the old cables too short.I chose the 100mm version of this stem, which means 100mm from the adjuster to the handlebars. I see that the company makes longer stems, up to 130mm. Ideally I would want one of those to give me more height and distance. However, for my purposes, the 100mm version works fine. Also I have a silver bike so I was concerned that the black stem would look weird. It actually looks great!
BrickPig
Bewertet in den USA am13. September 2015
I bought this adjustable stem to move up the handlebars on my MTB. Per the item title description, this item fits bike with a 7/8" diameter steering tube and 1" diameter handlebars. If you have a 1" steering tube, take a look at the T02 model.The original stem did not have much range of height adjustment and also the horizontal portion was too long which placed the handlebars too far forward. This stem has a much wider range of height adjustment and the angle of the stem can also be adjusted. It is a well made quality product and made my MTB much more comfortable to ride. Love it!
Alex Marsilio
Bewertet in den USA am11. April 2014
This stem worked great for my single speed conversion. Wish i would have ordered the longer stem, but that was my own fault. Adjustabilty is fantastic and it locks nice and tight. Great product/
Produktempfehlungen
34.55€
14 .99 € 14.99€