Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDas universelle Bremsleitungsanker-Set für die vordere Bremsleitung sorgt für einen sicheren Reifenabstand bei voller Federung. Die sichere Montage eliminiert unnötige Bewegung der flexiblen Bremsleitung und ABS / Raddrehzahlsensor.
NLS
Bewertet in den USA am17. September 2023
I used the JK specific style for the front brake hoses on my 2016 Jeep with only a 2" lift. They worked perfectly. Since the front moves more, the hoses I got (for 4-6 inch lift) were a bit long, but not too long. The rear were too long, and I had problems keeping them from rubbing, or hanging out where they might snag on something. It may be hard to see from the photo, but these worked to "anchor" the hoses out of the way. Make sure you check them through the entire suspension travel. If you have a hose that needs to be able to move, brake or other, but needs to be restricted, these might work. Check the dimensions listed. They're probably bigger than you think.
Joel Sochayseng
Bewertet in Australien am 6. Dezember 2022
Used it on couple beach runs other than that will test it this month flexing on rock terrains and see how it goes fingers crossed
MP200668
Bewertet in den USA am24. Januar 2022
Very easy install and needed if you have lifted your jeep and added longer brake lines. These brackets allow you to attach to a shock or nearby bolt, insert you brake and abs lines, zip tie them and bingo. Mine are placed to keep the lines away from the springs, shocks and sway bars.
Guy Locke
Bewertet in Australien am 25. Juli 2020
The perfect solution on my Jeep JK 4” lift, no more dodgy cable ties 🤫 holds brakeline + ABS sensor cable snug 🙌🏻 easy to install don’t hesitate ! You wont regret this purchase.
R. Nada
Bewertet in den USA am12. Oktober 2020
I was originally excited when I found these. I had planned to use them while installing a set of Wilwood Brakes, in order to hold the lines up front. I really liked the split design where you can use wire ties to hold them on; this makes installing them a breeze. However, the issue I ran into was the angle of the mounting strap vs. the rubber part - had it been rotated 90 degrees from how it was designed, I probably could have used them. However, given their odd angle, it seemed like no matter what direction I tried to mount these, things just didn't seem to be what I needed. This might be specific to my application, but i just felt the angle was sort of out of whack to what would have really been helpful.Also, the thickness of the part with the holes in it is really thick. I mean, it's way more thick than needed. This means that bending the mounting strap part (where the holes are) is next to impossible. I suppose that's personal preference, but it just seemed a little over engineered to me and the crazy thick plate steel didn't help matters as far as attempting to bend things and mount these. In the end, I just gave up and returned them. I will have to fabricate something myself or just run a protective sleeve or something.Good design all in all, but in actual application, just couldn't make it work for what I needed. Also, the cost is way through the roof for what they really are. If they had only cost $15 I might have just tossed them in the parts bin and made something else out of them. But at nearly $40, they are just way over the top cost wise.
Produktempfehlungen
![Stahlflex Bremsschläuche kompatibel mit BMW 3er E36 328i - 193 PS Bj.1995-1998 [V2A Edelstahl]](images/loading.gif)
159.90€
62 .99 € 62.99€